What is the procedure to mount an upper band on a 1903-A3 when the stock has no hole drilled or the new band's holes do not align with the hole that has already been drilled in the stock?
What is the procedure to mount an upper band on a 1903-A3 when the stock has no hole drilled or the new band's holes do not align with the hole that has already been drilled in the stock?
- Glue dowel flush in any old holes,
- apply band,
- mark new hole locations on both sides,
- remove band,
- drill halfway from each side, hoping to meet in the middle.
Lets see if I can get the link to work....
http://www.jouster.com/forums/showth...ght=upper+hole
http://www.jouster.com/forums/showth...ght=upper+hole
Thanks for all the information. I am embarrassed to say that I asked the same question way back in October of 2013. This time I will print out the answers. This old age sure gets more and more crazy as time goes by!