H&R Punisher nearing completion.

[nf1e]

The Punisher will get a chance to meet it's new OSS HD-Magnum TI suppressor this afternoon.
Receiver is Bula/H&R with all H&R Parts except the barrel which is Bula 16" ultra with 5/8-24 suppressor ready.
Scope is Hi-Lux M-40 on IDF optics mount. Muzzle device is OSS brake/adapter. Stock is usgi with one of Hawk's Ambi kits installed. Whatta Hobby!

H&R Punisher 1.jpgH&R Punisher 2.jpgH&R Punisher 3.jpgH&R Punisher 4.jpg

[nf1e]

Suppressor installed.

Bula ultra 5.jpgBula ultra 6.jpg

[lyman]

how quiet is that rig?

[nf1e]

Haven't put a rnd through this full set up yet. Only had visitation today and the suppressor went back in lockup till paperwork comes back. Last one was reduced enough that foam ear plugs were quite comfortable.

[nf1e]

Been working on and off since last fall on this project. Rifle is home build using an H&R/ Bula Defense Systems receiver with H&R bolt, op rod and trigger group. Barrel is a Bula Defense Systems 16" suppressor ready with their unitized gas system. Hope to get the OSS suppressor out of the clink soon. Put her in a used painted heavy fiberglass stock from the PX today and installed one of Hawk's fine kits. Magpul bipod is attached with a Versapod rail. Scope is a Redfield repro 3-9 sitting in an IDF mount and rings. Hope to be getting the OSS suppressor out of the clink soon. Whatta Hobby!


H&R Punisher coming along..jpgH&R Punisher coming along1.jpg