Just bought my first 1911 (Springfield Range Officer) and consequently, the reloading tooling from lee. I've loaded lots and lots and lots of rifle rounds, but darn few pistol rounds. I followed directions and have made and shot about 100 reloads. No real rocket science. I'm loading 230gr round nose bullets. Nothing fancy.

I notice that the bullets tend to tip a bit and bulge the case on one side sometimes. Not a lot, just a little. rounds all chamber just fine. I've belled the cases just enough to easily set the bullet in the case. Light taper crimp as the last step.

I have no interest in making this complicated or expensive. Are there any simple tips or tricks to be a little more consistent with seating, or is this perfectly normal and typical to have a bit of bulge? I notice that the cheap Armscor factory ammo shows some of the same bulge.
Thanks!