Warming up with new load for the 10 dot challenge

[nf1e]

Nice, what are you using for bedding and what are you setting the draw pressure to? Type of unitizing on the gas system? Trigger work method? Barrel and ammo? Been at this since 1966 so I am always interested in hearing the methods used by others.

[lyman]

it was Accraglass bedded, I built it about 1985,
wanna say mig welded the gas system,
standard trigger slick up

Barnett USGI heavy, circa the early 80's

I have a can of M118 left and maybe 100 rounds of Special Ball to run thru it,

I also have a standard weight SAK NM barrel in the safe if I ever need it,

no clue what the draw pressure is, that was not covered in the notes

[nf1e]

Thanks. The M118 is top shelf. The existence of enough draw pressure is paramount to getting actual sub moa performance from an M14 type rifle. Without it one is simply pissing in the wind.