anyone know how to remove the big knob on the m-1d scope mount

[goo]

so i can adjust the offset screw and bore sight the scope?

thx,
goo


m1d-3.jpg

[five 0]

Are you talking about the knob that screws into the barrel block?

so i can adjust the offset screw and bore sight the scope?

thx,
goo


m1d-3.jpg

[goo]

the big knob. i needa remove it the tweek the itty bitty offset correction screw

[goo]

how do i remove the big knob?


offset.jpg

[goo]

this might explain the problem but i don't see an answer,

http://garandforum.proboards.com/thr...ignment?page=1

[StockDoc]

are you talking about the locating pin that is next to the mount screw?

https://images.search.yahoo.com/imag...t&type=sbc_dsl

[StockDoc]

this will probably help you some "How to set a mechanical zero on the M84"

https://www.youtube.com/watch?v=sqQrkTrWq5U

[StockDoc]

how do i remove the big knob?


offset.jpg

not a screw but a locating pin, it does not move

But I have thought about removing the pin and putting a set screw there, or a fine Diamond hone to adjust. Until then, I had good luck using this video and a laser bore sighter. https://www.youtube.com/watch?v=sqQrkTrWq5U

Hope this helps

[goo]

that was very helpful. thank you so much, stock doc.

[StockDoc]

welcome