Search:

I recently picked up some Ohaus molds, 2-24-095 and 1-24-085. They appear to be new old stock in original factory boxes. They are 6mm molds. I know Ohaus sold the division in the 70's to RCBS but...

Merry Christmas to all at Jouster2!
Matt

It appears my phone was switched off of desktop view! Fellow shooter JB White had the answer and hats off to him. The other viewing screen had no controls, very limited and a pain to look at the...

Well, you are correct! Back to the old screen finally! Thank you JB White! How it ever switched is a mystery to me!

Thank you for the reply. I use a LG G2 phone. Its a few years old yes, but one must try and keep them as long as you can considering the cost of the new models.

The old viewing page does not show anylonger on my phone. There is no control panel. Completely different format. Is the site mobile friendly? What am I doing wrong?

Removed by Matt

Removed by Matt

Pretty, yes and pretty expensive also. I do not use Berger bullets as I still have thousands of Remington Core-loks, Winchester power points and silver tips purchased from Midway when they had their...

I have used berrys 150 gr. 30 caliper bullets for years and years. What I have found is sorting the bullets by weight insures great accuracy. The berrys vary by a full grain and a half. I keep...

Cast bullets are plain base or gas check base. Most places you buy cast bullets might not offer the gas check design. The mould determines that. The gas check fits over the resess and then is...

Have used standard RCBS 243 dies since I bought my first 243 back in the sixties. I have always been frustrated with run-out after seating bullets. I purchased the Hornady concentricy set up when...

I have read your posts for years and enjoy your demeaner. I have taken the position of not arguing nor posting anything negative in the future. I just want to help people do the correct procedures...

No one has posted here for days and days. It's disturbing to see everyday the same posts with no traffic.
Either most of the active people lost interest or do not even know Jouster2 exists.
Such a...

Removed by Matt....

Removed! No viable responses!
Matt

I have used Lyman bullet lube since I started casting in the late fifties. I used their alox blend for years and when orange magic came out I bought a heater and never used anything else. As others...

I have used many different powders in the 243. Many displayed inconsistencies so were eliminated from further testing. IMR 4350, H4350, AA4350, IMR4831, RL15, and H414 all showed consistent...

Matt

Removed by Matt Anthony

Removed by Matt Anthony

Removed by Matt Anthony

I just pulled 45 acp military surplus as it was corrosive using a impact type puller. Bullets cannot be used. Heavy crimp plus decreased diameter. I have pulled alot of 30/06 military and never...

Removing post for personal reasons!
Matt

Removed by Matt