so i can adjust the offset screw and bore sight the scope?
thx,
goo
Attachment 33911
so i can adjust the offset screw and bore sight the scope?
thx,
goo
Attachment 33911
the big knob. i needa remove it the tweek the itty bitty offset correction screw
how do i remove the big knob?
Attachment 33919
this might explain the problem but i don't see an answer,
http://garandforum.proboards.com/thr...ignment?page=1
are you talking about the locating pin that is next to the mount screw?
https://images.search.yahoo.com/imag...t&type=sbc_dsl
this will probably help you some "How to set a mechanical zero on the M84"
https://www.youtube.com/watch?v=sqQrkTrWq5U
not a screw but a locating pin, it does not move
But I have thought about removing the pin and putting a set screw there, or a fine Diamond hone to adjust. Until then, I had good luck using this video and a laser bore sighter. https://www.youtube.com/watch?v=sqQrkTrWq5U
Hope this helps
that was very helpful. thank you so much, stock doc.
welcome