anyone know how to remove the big knob on the m-1d scope mount [Archive]

goo

01-12-2016, 03:13

so i can adjust the offset screw and boresight the scope?

thx,

goo
33912

joem

01-12-2016, 05:13

Nerver tried it on mine but I've seen the M1D barrels and there is a threaded hole in the block that the scope mount goes to. I imagine there will be rust or some type of thread locker to hold it in place. Good luck don't bust it.

StockDoc

01-12-2016, 05:20

I believe it is on permanently

goo

01-12-2016, 05:51

so how do you tweek the itty bitty offset (windage) screw that makes up for the scope offset?

goo

01-12-2016, 06:03

how do i remove he big knob to tweek the offset screw?

33918

goo

01-12-2016, 06:16

this might explain the problem but i don't understand the solution,

http://garandforum.proboards.com/thread/452/m1d-scope-alignment?page=1

i stuck a dime in there as a shim..it was a bit too much. looks like shiet anyway.

jgaynor

01-13-2016, 04:09

There is no "offset screw" what you are seeing is the butt end of a spring loaded plunger. The other end of the plunger is pointed and engages the grooves machined in the backside of the large knob. Provides the ratchet effect as the knob is tightened.

The knob is not meant to come apart from the rest of the bracket.

five 0

01-13-2016, 07:13

If anyone knows of the dimension of the screw that attaches to the knob or has a screw let me know

goo

01-14-2016, 05:59

i'm guessing the m-1d wasn't intended to hit bad guys at much less than 300 yards. has anybody got theirs zeroed for say, 150 or 200 yards? 200 yards is about as far as i get to shoot. generally offhand with iron sights ( o3's, garands, m-1a, enfields, swede mausers, etc.) but i would like t0 zero the m-d for that range

goo

01-14-2016, 02:06

There is no "offset screw" what you are seeing is the butt end of a spring loaded plunger. The other end of the plunger is pointed and engages the grooves machined in the backside of the large knob. Provides the ratchet effect as the knob is tightened.

The knob is not meant to come apart from the rest of the bracket.

thanks. i just figgered that out... boy! do i feel dumb

Twinson

01-19-2016, 06:20

Your problem is the repro mount. Those will give you a world of grief. Find a USGI and have no worries. Jim

StockDoc

01-19-2016, 06:28

Even the originals are not just slap together. What really is needed is a good set of mounting instructions to come with the scope and mounting. Neither is supplied by the makers