PDA

View Full Version : Trapdoor Metal Pistol Grips


1mark
02-15-2015, 12:47
I am looking at 2 Trapdoor rifles. Both have the metal pistol grips that screw into the trigger guard. I did find an article on Trapdoor collector but I am trying to find more information. From the information on the site these are original and not reproductions. When did that come out? Were they for competition shooting?
JimF
02-15-2015, 01:41
Unfortunately these grips were installed using the same rear screw hole in the trigger plate (with a longer screw) as the standard TD.

This puts the grip FAR to much to the rear!

I had one installed . . . then removed it . . . . 'cause it was all but useless! (Maybe if I had a larger hand!)

These grips needed to be about one-half to three-quarter inch CLOSER to the rear of the trigger guard bow to be of any benefit. --Jim
45govt
02-15-2015, 07:44
Mine works great:icon_lol:

http://pic100.picturetrail.com/VOL596/2374373/20394583/398171161.jpg
Dick Hosmer
02-15-2015, 08:35
Tom, does your LRR have a service or Hotchkiss butt?
Tom Trevor
02-16-2015, 09:24
Dck, That is not me, he is in San Jose, but my long range does have the Hotchkiss plate
Dick Hosmer
02-16-2015, 10:06
You mean there are TWO walnut-gripped ones?

45govt: Would you mind providing the serial number of the rifle shown? If you do not wish to publish it, you can email me at richardahosmer@comcat.net, or send a PM. Many thanks.
sdkrag
02-17-2015, 06:16
There were or may still be reproduction metal grips available through S&S. I used one for years when I shot competitively.
45govt
02-18-2015, 05:14
You mean there are TWO walnut-gripped ones?

45govt: Would you mind providing the serial number of the rifle shown? If you do not wish to publish it, you can email me at richardahosmer@comcat.net, or send a PM. Many thanks.

Dick
That is a grip my dad made for me based on Tom's LR with the Kelton grip.
Pretty good job eh?

Don
Dick Hosmer
02-18-2015, 05:56
Pretty good doesn't do it justice - that is really nice!