PDA

View Full Version : Loading 9X19 soon


joem
10-23-2014, 01:20
In the next few weeks I will start loading 9X18. Anything to watch out for? Any gotcha's? I'll be using 93 gr LRN.
Litt'le Lee
10-23-2014, 02:22
use your barrel for case gauge--listen for that clunk when you drop a round in-that's my only clue to a good round
joem
10-23-2014, 03:29
I prefer to use a max length case gauge if I can find one. If not I'll use the barrel.
dogtag
10-23-2014, 04:15
I load it but with cast bullets so I'm not much help - except,
I put a taper crimp on mine, not too tight.
joem
10-23-2014, 05:05
I plan on ordering some cast lead soon.
Tuna
10-23-2014, 06:36
The 9x19 or 9mm Luger is an easy round to reload. And the 9x18 Makarov is also easy to load for. So which one are you loading for?
BudT
10-23-2014, 08:02
I should get a 2 cavity mold RN 147 or so and cast my own for my Glock. Most don't pick up their brass so that shouldn't be any problem.
joem
10-24-2014, 04:24
The 9x19 or 9mm Luger is an easy round to reload. And the 9x18 Makarov is also easy to load for. So which one are you loading for?

Bad fingers hit wrong buttons. I will be loading 9X18 as soon as my supplies come in.
Tuna
10-24-2014, 09:48
Bud, unless you change the barrel in your Glock then you should not be shooting lead in it. In fact Glock will cancel any and all warranty on your Glock if you use not only lead reloads in it but any reloads in it. It's all comes from the polygonal rifling used by Glock as it can cause a build up of lead and that will raise the pressures and the gun can be damaged by that.

Joe what model Makarov are you going to be shooting? It's not a model 82 is it?